Email:wuxichangfu@163.com Wuxi Changfu Tractor Manufacturing Co.,Ltd

Wuxi Changfu Tractor Manufacturing Co.,Ltd

Machine Adjustment Of Rotary Tiller

1. Adjust the left and right level. The tractor with the rotation of the first stop on the flat ground, reduce the rotary tiller, so that the blade distance to the ground 5 centimeters, to observe the left and right tip of the height is consistent, in order to ensure that the operation of the knife shaft level consistent, deep tillage.

2. Horizontal adjustment before and after. When the rotary tiller is lowered to the required tillage depth, the angle of the universal joint is observed and the rotary tiller is close to the horizontal position. If the universal joint angle is too large, can adjust the upper lever, so that the rotary tiller in the horizontal position.

3. Elevation adjustment. In Rotary tillage, the angle of universal joint is not allowed to be greater than 10 degrees, and no more than 30 degrees when turning. Therefore, the lifting of the rotary tiller, for the use of the available screws in the position of the appropriate location of the handle to screw the limit; with a high degree of adjustment, the promotion should pay special attention, if the need to raise the rotary tiller, the power of the universal joint should be removed.


Copyright © Wuxi Changfu Tractor Manufacturing Co.,Ltd All Rights Reserved.
QR Code